Opinion I wanted to know how to calculate the effectiveness or efficiency of the Kettle reboilers. Regards mann

The use of product is really easy, but the demo leaves some doubts on the obtained results.

It does not work with open office, which is rather unfortunate because a lot of us use Open Office.

Very easy and user friendly little program for all kinds of simple construstions. Just what you need when things are straight forword and you just want to be on the safe side or find the most economical solution.

This is a good software package. I quite like it. It makes beam sizing very simple and it allows quick checking with other shapes and sizes to maximize economy. Some of the help is a little hard to understand--I think it may have been originally written in another language.Jon.

What little I have used of it so far I really like it . It does exactly what I was looking for.

I-Beam Calculation I have a specific question about how to use the product to calculate the bending load for an I-Beam. Please allow me a day to compose a message, which describes what I'm trying to do.Thanks,Ed Koch, Jr.

MITCalc Review I like the software, the interface could be a bit easier to use, but solving virtually any type of beam equation is fairly straightforward and the software has quite a bit of flexibility allowing easy modeling of indeterminite beams.Some complaints would be that the bending moment is displayed in ft-lbs not in-lbs which would match the designated units. To enter custom moment of inertia's and areas is not intuitive and the rectangular tube shape omits fillets so it doesn't match the book values for structural members.Other than those very minor issues, the software is fantastic overall and relatively ...

I am looking for Rack & pinion gear calculation.how i can use this sheet to get required information.

The program works very well. I will evaluate it a little further before deciding whether to purchase as it appears far in excess of what I need

Dear Sir/Madam,Before buying your software I checked the demo. of your module for spur and helical gears calculations.Unfortunately the only option I found is calculations without errors, means I could not check tolerances/deviations of dimensions over pins subiect to backlash limits or even change backlash in the table and receive result to this data (all data are for \"0\" backlash without any possibility for changes), posibility to modify tooth thickness and get the dimension over oins or span over teeth, entering DIN or ISO or AGMA quality grade and receive tooth errors/deviations etc.In case there ...

We are looking for program to check existing set of gears, unfortunately Spur Gear Calculations 1.16 do not support this type of calculations.Regards,Steve

MITcalc review Your spreadsheets for Metric-ISO gear design are very good. But we badly need a good comprehensive textbook in English. It seems that the only good books are in German. I bought 4 of your gear design spreadsheets.Thanks for your good work.Prof. Hatem Radwan

MITCalc Review It is a quite easy-to-use spreadsheet. The main advantage is that it is like an algorithm; if you follow it step by step, you will end up to a result. Its disadvantage is that it doesn't comply with other standards, like DIN and ISO, and it could be as an option. Nevertheless, it is quite good for solving simple pair of gears, and the results are more than satisfactory. I use it mainly to have a preliminary calculation before I turn to the original AGMA analytical calculations (that is, all the background calculations that the spreadsheet does) or to check ...